Is it possible to configure an interface to support a full non channellized T1? If so how?
The T1 interface goes up up but after I config the serial interface goes UP UP then after about 10 seconds the serial goes up down. The T1 never goes down. version 12.2 service timestamp service timestamps log uptime no service password-encryption ! hostname Router ! boot bootldr bootflash:c7200-boot-mz.120-17.S card type t1 1 enable password ! ! controller T1 1/0 framing esf service-type data clock source internal linecode b8zs cablelength short 110 channel-group 0 timeslots 1-24 ! ! interface Serial1/0:0 no ip address ! Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=52090&t=52090 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
