I just done a test to verify ... Fast switching cache is established based on egress interfaces. So when a packet comes on an ingress interface (cache empty), first packet is routed (process switched) and an entry is cached for egress Interface (sh ip cache). If I disable fast switching on the egress interface, the entry disappears and no more entry are cached for this interface when packet come.
For me, issuing the command "no ip route-cache" on an interface, disables caching for this interface. Stephane ""Priscilla Oppenheimer"" a icrit dans le message de news: [EMAIL PROTECTED] > Stephane Litkowski wrote: > > > > If you don't want to (or can't) use CEF, just use the command : > > no ip > > route-cache on destination interfaces to desactivate FAST > > SWITCHING. > > Destination interfaces or ingress interfaces? I would think you would > disable it on the incoming interfaces to disable the automatic behavior of > using the fast-switching cache when a packet comes in. Correct me if I'm > wrong, please. Thanks. > > Priscilla > > > > NB : using CEF is more efficient than using PROCESS SWITCHING. > > > > > > Stephane > > > > > > ""Russell Heilling"" a icrit dans le > > message de news: > > [EMAIL PROTECTED] > > > ""afshin"" wrote in message > > > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > > > > I have got two internet links from two ISPs boths of which > > are directly > > > > connected to the lan . > > > > I would like to set the default gateway of my clients to > > the 3660 router > > I > > > > have on my network so that it will load balance the > > outgoing traffic > > > accross > > > > the two seperate internet links. > > > > I though maybe two equal cost default routes would result > > in load > > > balancing > > > > between equal cost paths . but it didn't work. > > > > Is there a command to allow load-balancing between equal > > cost static > > > routes > > > > , that I am missing ? > > > > Policy routing is not quite what I want because the load > > will not be > > quite > > > > balanced. > > > > Any clues ? > > > > > > Default load balancing is per destination, so if you are > > testing from a > > > single workstation you will always hit the same link. To get > > a more even > > > load sharing you'll want to enable per packet load sharing. > > To do this > > > globally enable CEF ("ip cef" in global config mode), and > > then add the > > > following command to the interface config on the interfaces > > connecting to > > > the ISPs: "ip load-sharing per-packet". > > > > > > Hope this helps. > > > > > > Russell Heilling > > > http://www.ccie.org.uk/ Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=53963&t=53901 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
