9/26/2002   11:11pm  Thursday

Professionals -  I have two WIN95 laptops --- one is connected to a Catalyst
3920, then token ring 0/0, the other to a Catalyst 1924, then ethernet 0/0

Barbados#sho cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
                  S - Switch, H - Host, I - IGMP, r - Repeater

Device ID        Local Intrfce     Holdtme    Capability  Platform  Port ID
000577:25E400 (HSTRA Catalyst 3920)
                 Tok 0/0            172         B S       CAT3920   1/2
Gozo             Eth 0/0            156         T S       1900      7
2522_            Ser 0/1            172          R        2522      Ser 1
Barbados#

The PC's could ping each other even before I enabled EIGRP --- they are
directly connected.
I wanted to set up SR/TLB so I entered some commands as you can see in the
log at the bottom of this post
Even after setting up SR/TLB the PC's cannot see each other in network
neighborhood, so in what way are they connected ?

http://www.cisco.com/warp/public/701/45.html#5

from above link:  "If you need to connect stations between Ethernet and
Token Ring which are local to the router, you must use SR/TLB "


sho run
Building configuration...

Current configuration : 2151 bytes
!
! Last configuration change at 22:26:24 UTC Thu Sep 26 2002
! NVRAM config last updated at 22:26:25 UTC Thu Sep 26 2002
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Barbados
!
enable password cisco
!
username richard password 0 cisco
ip subnet-zero
!
!
no ip domain-lookup

ip multicast-routing
ip audit notify log
ip audit po max-events 100
ipx routing 0005.3280.1b60
ipx maximum-paths 6
!
call rsvp-sync
!
!
!
!
!
!
!
!
interface Loopback11
 description EIGRP loopback
 ip address 12.8.1.2 255.255.255.255
 ipx network C812
!
interface Loopback12
 description DLSw loopback
  no ip address
!
interface Loopback13
 description ospf loopback
 no ip address
!
interface Loopback14
 description bgp loopback
 no ip address
!
interface Loopback215
 description RIP loopback
 no ip address
!
interface Ethernet0/0
 ip address 12.3.1.1 255.255.255.0
 ip accounting output-packets
 half-duplex
 ipx network C311
 ipx accounting
!
interface Serial0/0
 no ip address
 shutdown
 no fair-queue
!
interface TokenRing0/0
 ip address 155.15.15.1 255.255.255.0
 ip accounting output-packets
 ipx network 9BFF1
 ipx accounting
 ring-speed 16
!
interface Serial0/1
 ip address 12.88.1.2 255.255.255.0
 ip accounting output-packets
 ipx network C5811
 ipx accounting
!
interface Serial0/2
 no ip address
 shutdown
!
interface Serial0/3
 no ip address
 shutdown
!
router eigrp 90
 network 12.0.0.0
 network 155.15.0.0
 no auto-summary
 no eigrp log-neighbor-changes
!
ip classless
ip http server
ip pim bidir-enable
ip pim rp-address 20.0.9.11
!
logging trap debugging
logging 111.111.111.111
!
snmp-server enable traps tty
snmp-server enable traps config
snmp-server enable traps bgp
snmp-server host 111.111.111.111 richard  tty config bgp
!
!
!
!
voice-port 1/0/0
!
voice-port 1/0/1
!
dial-peer cor custom
!
!
!
!
!
line con 0
 exec-timeout 0 0
 logging synchronous
 full-help
line aux 0
line vty 0 4
 password cisco
 absolute-timeout 999
 login local
 full-help
!
exception dump 111.111.111.111
end

Barbados#sho ipx route
Codes: C - Connected primary network,    c - Connected secondary network
       S - Static, F - Floating static, L - Local (internal), W - IPXWAN
       R - RIP, E - EIGRP, N - NLSP, X - External, A - Aggregate
       s - seconds, u - uses, U - Per-user static/Unknown, H - Hold-down

7 Total IPX routes. Up to 6 parallel paths and 16 hops allowed.

No default route known.

C       C311 (NOVELL-ETHER),  Et0/0
C       C812 (UNKNOWN),       Lo11
C      9BFF1 (SAP),           To0/0
C      C5811 (HDLC),          Se0/1
R       4001 [13/02] via    C5811.0010.7b3a.e001,   24s, Se0/1
R       CB11 [07/01] via    C5811.0010.7b3a.e001,   24s, Se0/1
R      C5801 [07/01] via    C5811.0010.7b3a.e001,   24s, Se0/1
Barbados#sho ip route eigrp
     4.0.0.0/32 is subnetted, 1 subnets
D       4.0.0.1 [90/2809856] via 12.88.1.1, 00:37:05, Serial0/1
     12.0.0.0/8 is variably subnetted, 5 subnets, 2 masks
D       12.11.1.1/32 [90/2297856] via 12.88.1.1, 00:37:06, Serial0/1
D       12.88.0.0/24 [90/2681856] via 12.88.1.1, 00:37:06, Serial0/1
Barbados#sho rif
Codes: * interface, - static, + remote

Dst HW Addr    Src HW Addr    How   Idle(min) Vlan Routing Information Field
00a0.4c01.d886 N/A            To0/0       *      - -


Barbados#config t
Enter configuration commands, one per line.  End with CNTL/Z.
Barbados(config)#source-bridge ring-group 2000
Barbados(config)#source-bridge transparent 2000 1000 1 1

00:39:03: %LINEPROTO-5-UPDOWN: Line protocol on Interface VirtualRing2000,
changed state to up
00:39:03: %LINEPROTO-5-UPDOWN: Line protocol on Interface RingGroup2000,
changed state to up

Barbados(config)#int ethernet 0/0
Barbados(config-if)#bridge-group 1
Barbados(config-if)#exit

Barbados(config)#int tokenRing 0/0
Barbados(config-if)#source-bridge 1 1 2000
Barbados(config-if)# source-bridge spanning
Barbados(config-if)#
00:39:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface VirtualRing2000,
changed state to up
Barbados(config-if)#exi
00:39:48: %LINK-5-CHANGED: Interface TokenRing0/0, changed state to
initializing
00:39:49: %LINEPROTO-5-UPDOWN: Line protocol on Interface TokenRing0/0,
changed state to down
Barbados(config-if)#exit
Barbados(config)#exit
00:39:52: %LINK-3-UPDOWN: Interface TokenRing0/0, changed state to up
00:39:53: %LINEPROTO-5-UPDOWN: Line protocol on Interface TokenRing0/0,
changed state to up
Barbados(config)#exit
Barbados#
00:39:53: %SYS-5-CONFIG_I: Configured from console by console
Barbados#wr
Building configuration...
[OK]
Barbados#wr
Building configuration...
[OK]
Barbados#sho rif
Codes: * interface, - static, + remote

Dst HW Addr    Src HW Addr    How   Idle(min) Vlan Routing Information Field
00a0.4c01.d886 N/A            To0/0       *      - -
Barbados#config t
Enter configuration commands, one per line.  End with CNTL/Z.
Barbados(config)#bridge 1 protocol ieee
Barbados(config)#exit
Barbados#wr
Building configuration...

00:41:14: %SYS-5-CONFIG_I: Configured from console by console[OK]
Barbados#sho bri

Total of 300 station blocks, 300 free
Codes: P - permanent, S - self

Bridge Group 1:

Barbados#sho ip accoun
Barbados#sho ip accounting
   Source           Destination              Packets               Bytes
 12.3.1.12        155.15.15.15                   459               27540
 155.15.15.15     12.3.1.12                      457               27420

Accounting data age is 41
Barbados#sho ipx account
Barbados#sho ipx accounting
 Source                  Destination                Packets           Bytes

Accounting data age is 41

Barbados#clear ip accounting
Barbados#clear ipx accounting
Barbados#sho ip accounting
   Source           Destination              Packets               Bytes
 155.15.15.15     12.3.1.12                        5                 300
 12.3.1.12        155.15.15.15                     5                 300

Accounting data age is 0
Barbados#sho ip accounting
   Source           Destination              Packets               Bytes
 155.15.15.15     12.3.1.12                      553               33180
 12.3.1.12        155.15.15.15                   553               33180

Accounting data age is 4
Barbados#sho bri

Total of 300 station blocks, 299 free
Codes: P - permanent, S - self

Bridge Group 1:

    Address       Action   Interface       Age   RX count   TX count
0060.9789.812c   forward   Ethernet0/0       1          3          0
Barbados#sho rif
Codes: * interface, - static, + remote

Dst HW Addr    Src HW Addr    How   Idle(min) Vlan Routing Information Field
4000.0000.2000 N/A            -           2      - -
00a0.4c01.d886 N/A            To0/0       *      - -
Barbados#

thanks,

Richard

//




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=54302&t=54302
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

Reply via email to