Hi, We are facing a strange problem with PIX failover. We have two PIX = 525 (OS 6.0.1) in failover configuration. When the standby PIX is = rebooted for maintenance reasons, it came up and became the Active PIX = (which should not happen). The active PIX showed stateful failover link = failed and so the PIX was in failed state. Both the PIX are connected = through a stateful failover link (100Mbps) using a Crossover cable.=20 Is it a problem because both the PIX are connected using a crossover = cable? Is it recommended to connect through a switch? Has anyone faced a = similar problem?
Regards, Vamsi **************************Disclaimer************************************ Information contained in this E-MAIL being proprietary to Wipro Limited is 'privileged' and 'confidential' and intended for use only by the individual or entity to which it is addressed. You are notified that any use, copying or dissemination of the information contained in the E-MAIL in any manner whatsoever is strictly prohibited. *************************************************************************** Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=56199&t=56199 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
