Try setting to switch to autonegotiate ""Patrick Donlon"" wrote in message news:200210281321.NAA04008@;groupstudy.com... > Doe anyone have experience connecting a Cat 5K g-bit interface to a Fluke's > g-bit interface? Can't seem to get any layer 3 comms, here's the the show > interface below. NOTE the interface is NOT connected, when it is though the > status is "Connected" and all the relevant LEDs light up and the cable tests > are passed on the fluke OK > > Cheers > > Pat > > > (enable) sh port 5/1 > Port Name Status Vlan Level Duplex Speed Type > ----- ------------------ ---------- ---------- ------ ------ ----- ------- -- > --- > 5/1 FLUKE Optiview notconnect 1 normal full 1000 > 1000BaseSX > > Port Trap IfIndex > ----- -------- ------- > 5/1 disabled 456 > > Port Broadcast-Limit Broadcast-Drop > -------- --------------- -------------- > 5/1 - 0 > > Port Send FlowControl Receive FlowControl RxPause TxPause Unsupported > admin oper admin oper opcodes > ----- -------- -------- -------- -------- ------- ------- --------- -- > 5/1 desired off off off 0 0 0 > > > Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize > ----- ---------- ---------- ---------- ---------- --------- > 5/1 0 0 0 0 0 > > Port Single-Col Multi-Coll Late-Coll Excess-Col Carri-Sen Runts Giants > ----- ---------- ---------- ---------- ---------- --------- --------- ---- -- > --- > 5/1 0 0 0 0 0 0 > 0
Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=56429&t=56410 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]