Doe anyone have experience connecting a Cat 5K g-bit interface to a Fluke's
g-bit interface? Can't seem to get any layer 3 comms, here's the the show
interface below. NOTE the interface is NOT connected, when it is though the
status is "Connected" and all the relevant LEDs light up and the cable tests
are passed on the fluke OK
Cheers
Pat
(enable) sh port 5/1
Port Name Status Vlan Level Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- ---------
---
5/1 FLUKE Optiview notconnect 1 normal full 1000
1000BaseSX
Port Trap IfIndex
----- -------- -------
5/1 disabled 456
Port Broadcast-Limit Broadcast-Drop
-------- --------------- --------------
5/1 - 0
Port Send FlowControl Receive FlowControl RxPause TxPause Unsupported
admin oper admin oper opcodes
----- -------- -------- -------- -------- ------- ------- -----------
5/1 desired off off off 0 0 0
Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize
----- ---------- ---------- ---------- ---------- ---------
5/1 0 0 0 0 0
Port Single-Col Multi-Coll Late-Coll Excess-Col Carri-Sen Runts Giants
----- ---------- ---------- ---------- ---------- --------- --------- ------
---
5/1 0 0 0 0 0 0
0
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=56410&t=56410
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
