We cannot afford that equipment right now. Also ran the diagnostic test to find the clear channel, we found the channel but bridges didn't work.
Best regards, ""Tunde Kalejaiye"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > try using a spectrum analyser to determine if there is a strong RF > interference from somewhere close by....this is probably ur best bet. > > Tunde > > > ----- Original Message ----- > From: "Cisco Breaker" > To: > Sent: Thursday, November 21, 2002 9:04 AM > Subject: Wireless 350 bridge problem [7:57827] > > > > Hi All, > > > > We have installed Aironet 350 series bridges 2 months ago. They were > working > > fine until yesterday. Bridges are on the top of two buildings and they > > were and are clearly seeing each other, freshnel zone okey. But yesterday > > morning the network was gone. We have controlled the settings and set up > the > > bridges again. Checked that if they can see each other, yes. But it > doesn't > > work. Bridge link down. Then we have changed the rate to only 1 Mbit, > found > > a really clear channel and it started to work but really in a bad mood. > The > > client bridge was associating and then disappearing every 1 minute. Now > the > > wireless network is down. > > > > Has anybody faced a problem like this? > > > > Any help will be highly appreciated. > > > > Best regards, Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=57835&t=57827 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]