Well if you had set any write snmp community strings you could try an upload a config into the router that would allow you to get in via the vty.
John -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Tuesday, December 10, 2002 10:58 AM To: [EMAIL PROTECTED] Subject: Please help: 2600 console lost [7:58889] I've been working a few hours with a 2610 when suddenly, boom!!, I lost my console connection, now it doesn't respond to Ctrl-Break nor anything, I've rebooted it several times but it doesn't shows any single character on HyperTerminal. Unfortunately, the equipment is running (almost) default configuration, so now I can't get in through Aux or Vty. My Aux port respond but can't do much through it since no 'enable password' has been provided by default, so can't get to privileged mode. Once the box is booted, it looks good, its eth and serial interfaces comes up, so it doesn't looks like a flash or IOS corruption problem. Do you guys have any clue why I'm suffering this? Any workaround to at least have privileged access through Aux?? Maybe nvram got corrupted? there's any way to 'hard' reset nvram through internal jumpers?? Thanks very much in advance, RM. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=58963&t=58889 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
