TACACS+ server! -----Original Message----- From: Williams, Dave [mailto:[EMAIL PROTECTED]] Sent: Wednesday, January 08, 2003 9:33 AM To: [EMAIL PROTECTED] Subject: RE: User Privilege Level [7:60469]
Thanks for everyone's help. What I mean by "reset ports" is to re-enable the switch ports after they were err-disabled. These are Cisco 6500 series switches w/layer 3 blades. The switch is running Cat/OS 7.2(2) and on the layer 3 blade, IOS 12.1(11b). Since our technicians are in remote locations, if I can give them the ability to re-enable the ports without getting into config mode, they don't have to wait on one of our engineers to do it for them (which may take hours). I'll try to re-assign some set commands and see what happens. Dave Williams, CCDA, CCNA, CCSA Senior Network Engineer (402) 661-2143 -----Original Message----- From: Erick B. [mailto:[EMAIL PROTECTED]] Sent: Monday, January 06, 2003 9:37 PM To: Williams, Dave; [EMAIL PROTECTED] Subject: Re: User Privilege Level [7:60469] Dave, Priv. level 1 gives you basic show commands, etc. level 15 is full access like you mentioned. levels 2-14 don't have any special commands , but you re-assign commands to these levels for different users for example. Theres also a priv level 0 which gives you close to no commands on router IOS and you need to reduce the level 1 (default level) to 0 if you make the priv level 0 for line vty for example. I'm not sure if you can go to 0 on the switches. When you say reset ports, do you mean clean counters or shut/no shut the port? the latter would be config access. What type of switch is this and version of code? Awhile back when I was doing this for a client there was a minor bug with the priv commands and config mode for setting speed and duplex where the commands weren't saved properly. haven't checked that in quite awhile though. Erick --- "Williams, Dave" wrote: > I've been searching CCO most of the afternoon and > can't seem to find the > correct URL. I'm looking for a way to allow a > technician to reset ports on > a switch and look at interface stats, but not allow > configuration access. > > For example, I know that user level 15 is the same > as having the enable > password and user level 1 is the same as a generic > user, but I don't know > what the other levels do for me. > > Thanks in advance for your help. > > Dave Williams > Senior Network Engineer > (402) 661-2143 [EMAIL PROTECTED] __________________________________________________ Do you Yahoo!? Yahoo! Mail Plus - Powerful. Affordable. Sign up now. http://mailplus.yahoo.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=60610&t=60469 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]