I have a strange problem or serious problem. I configured a Cisco 1605R router which was configured before. This time, I only changed E0 and E1 ip address, and default route through the console. After that, I put it into the server room, booted it up, but I couldn't ping the interfaces. I thought maybe the interfaces were not up, I should run "no shutdown" command.
I took it back to the office, connected the console port to the com1, but it never comes back. It is dead. It can not boot. Nothing shows in Hyper Terminal. Maybe one time of ten times of reboot just shows @ . That is all. Note: console cable, com1, and Hyper terminal are working fine. Any ideas? Thanks Shawn _________________________________________________________________ STOP MORE SPAM with the new MSN 8 and get 2 months FREE* http://join.msn.com/?page=features/junkmail Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62179&t=62179 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]