Hi All I am having the T1 CSU/DSU card. While configuring the remote loopback settings, i am facing some problems like, whatever has been given in cco is not happening.
The following the excerpt from the cco doc. The service-module t1 remote-loopback command specifies whether the T1 CSU/DSU goes into loopback when it receives a loopback code on the line. The [full | payload] parameter specifies whether the T1 CSU/DSU accepts full loopbacks (CSU loopback) or payload loopbacks (DSU loopback). The [v54 | alternate] parameter selects the loopback code that the T1 CSU/DSU recognizes or generates with the loopback remote command. The "standard" pattern (specified by ommitting the [v54 | alternate]) is used in the United States and consists of a repeating bit pattern "10000". The alternate pattern is used in Canada, and is the inverse of the "standard" code: "01111". To disable remote loopbacks, use no service-module t1 remote-loopback. The T1 module will not generate loopback codes via the loopback remote command if configured for no service-module t1 remote-loopback. But when i am configuring on the router, if i give the command service-module t1 remote-loopback full lternate, this gives the format error. Also if i give only service-module t1 remote-loopback payload and hit the enter key, it gives the incomplete command msg. I want to know what are the sequence of commands used in real time networks The standard pattern what the doc says, will not be taken in CLI. only for full it is available but for payload we need to give v54. but v54 is given as optional. I am getting much confused. Thanks in advance Regards Deepak Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62470&t=62470 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]