Some routers have a jumper that forces the console port to 9600. I was not able to find it for the 4000. Perhaps someone else knows if the 4000 does or does not have such a jumper. As I suggested before - try different console speeds.
> -----Original Message----- > From: Domingo Ferrero [mailto:[EMAIL PROTECTED]] > Sent: Wednesday, February 05, 2003 11:10 AM > To: [EMAIL PROTECTED] > Subject: Re: Cisco 4000 Series [7:62507] > > > The router dont work because in the screen a rare sequence of commands > appears "ajdsdgaqljiohangasdsa" and not the CTRL Break functions > > As is able resetear the router to traves of jumpers so that > return to have > the registration 0x2102 since accidentally himself change by > another that is > not correct > > Thanks and Regards > -- > --- > Domingo Ferrero Saavedra [EMAIL PROTECTED] > Dept. Sistemas, IdecNet S.A. > c/ Guzman el Bueno 125 > Madrid-Spain > Tfn: +34 91 824 00 00 > http://www.idecnet.com > --- > ""Daniel Cotts"" escribis en el mensaje > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > > There could be several issues here: > > 1) Break sequence doesn't work. This may be due to the > terminal emulation > > software that you are using. Some versions of Hyperterminal > would not > > properly send the break signal. One solution is to go to > the Hilgraeve > site > > (hope I've spelled that correctly) and download a newer > version. If you > have > > another router, see if you can send a break to it. > > 2) When you say that the router doesn't start - does > anything appear on > the > > screen? If so, is it readable? If it is not readable you might try > different > > console speeds. > > 3) Your IOS upgrade may have failed. Check the Cisco web site for > > documentation on that. > > Here's the link to the config register page: > > > http://www.cisco.com/en/US/products/hw/routers/ps285/products_ > installation_g > > uide_chapter09186a008007cb01.html > > > > > -----Original Message----- > > > From: Domingo Ferrero [mailto:[EMAIL PROTECTED]] > > > Sent: Wednesday, February 05, 2003 8:58 AM > > > To: [EMAIL PROTECTED] > > > Subject: Cisco 4000 Series [7:62507] > > > > > > > > > I have a router of the series 4000 of cisco, I have changed > > > it the IOS but > > > there I am position in in conf reg a value that is not 0x2101 > > > neither 0x2102 > > > and the router does not start, I have tried to enter way > > > rommon but does not > > > function any tecla of break. > > > > > > Someone it knows like podria to recover the router > > > > > > > > > Thanks and Regards, > > > > > > -- > > > --- > > > Domingo Ferrero Saavedra [EMAIL PROTECTED] > > > Dept. Sistemas, IdecNet S.A. > > > c/ Guzman el Bueno 125 > > > Madrid-Spain > > > Tfn: +34 91 824 00 00 > > > http://www.idecnet.com > > > --- Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62537&t=62507 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
