Dear Fahim
Here
Define The traffic for policy routing:
access-list 150 tcp any any eq smtp
Then Make a Route-map policy
route-map permit
match ip address 150
set ip next-hop
Now assign it to some interface:
Interface configuration mode>ip policy route-map
Hope it helps
Hakopian
""fahim"" wrote in message
news:[EMAIL PROTECTED]
> Hi Guys
> Need Help in Policy Routing. I have a Cisco 2610 router with Pix behind,
The
> 2610 has two WAN Connections, S0-256Kbps leased line and ATM0-DSL line
> 512Kbps, going to two differenct ISP, with different IP addresses.E0 will
> connect to PIX outside interface,
> I need to configure SMTP Traffic to route thru leased line, HTTP traffic to
> route thru ATM0, DSL line. I think it can be done by Route Map (policy
> Routing), cannot find documents in Cisco's website, or do I need additional
> router to do this.
> If anybody had done similar setup pls do provide a sample configuration, or
> if this setup will not work, what is the alternate suggestion.
>
> appreciate your early reply.
>
> thanks n regards
> fahim
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=63695&t=63692
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
