By the sounds of your email, it appears as though you where able to connect, but have since connected and abnormally exited .. Use the command show sessions to list all the open connections. Then you can use the command disconnect to disconnect whatever session you want.
To prevent this sort of thing happneing again, set a timeout on the line. eg below, line 1 16 session-timeout 10 exec-timeout 10 0 no exec no activation-character terminal-type console transport input all escape-character BREAK stopbits 1 flowcontrol hardware John Neiberger wrote: > > At the line level in your config make sure you have 'no exec' > configured > on the lines leading to your 'remote' devices or this sort of > thing will > happen all the time. > > HTH, > John > > >>> "McHugh Randy" 2/24/03 3:55:19 PM >>> > It appears that I cannot establish a telnet session to my > routers from > the > term server. How can I clear the line > TS#sh ses > % No connections open > TS#r1 > Translating "r1" > Trying r1 (1.1.1.1, 2097)... > % Connection refused by remote host > > TS#r2 > Translating "r2" > Trying r2 (1.1.1.1, 2098)... > % Connection refused by remote host > > TS#clear line ? > Line number > aux Auxiliary line > console Primary terminal line > tty Terminal controller > vty Virtual terminal > > TS#clear line > thanks > Randy > > Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=63700&t=63660 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
