Elijah; You can isolate which end is sending the errors by putting up loops at a test access point as close to the A and Z end as you can get. With the loopbacks up, the side that still sees the errors is transmitting them. If you are certain that it is the fiber daughter card that is transmitting the errors, then replace the one that is on the side that still sees errors with the loop up.
M -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Elijah Savage Sent: Friday, February 28, 2003 8:27 AM To: [EMAIL PROTECTED] Subject: FCS Errors between 2 5500's [7:64072] All, Last night I had to shutdown a gig fiber trunk between 2 5500's to run on a 100M trunk we setup as a backup. The FCS errors are only showing up on one side the fiber between the 2 cats were replaced but the errors are still showing up. Which side would you all say you would replace the fiber daughter card the one with the errors or the side without the errors? Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=64302&t=64072 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
