How would I enable the drivers. If the modules are being loaded shouldn't I be using them? In lsmod and /proc/modules it shows the tulip and 8139 modules: I couldn't find rtl8139. ------------------- lsmod 8139too 20384 0 mii 4896 2 8139cp,8139too tulip 44096 0 /proc/modules tulip 44096 0 - Live 0xf8965000 8139too 20384 0 - Live 0xf8936000 mii 4896 2 8139cp,8139too, Live 0xf8908000 ------------------------- This is the output from ifconfig: eth3 Link encap:Ethernet HWaddr 00:a1:b0:10:7f:f1 UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) Interrupt:16 Base address:0xec00 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:81 errors:0 dropped:0 overruns:0 frame:0 TX packets:81 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:7312 (7.1 KiB) TX bytes:7312 (7.1 KiB) and my /etc/network/interfaces: # The loopback network interface auto lo iface lo inet loopback # The primary network interface allow-hotplug eth3 iface eth3 inet dhcp hostname Debian I think this is correct.
_______________________________________________ clug-talk mailing list [email protected] http://clug.ca/mailman/listinfo/clug-talk_clug.ca Mailing List Guidelines (http://clug.ca/ml_guidelines.php) **Please remove these lines when replying
