Interesting. Do you know which cards eth0 and eth3 belong to? It may be in your boot log, or the output of 'dmesg'.
Also, do you know if your network cards work in this configuration when you are using another OS? It may be a BIOS configuration problem (IRQ related perhaps.) Just a thought. -Mark C. On Sun, May 30, 2010 at 10:57 AM, Joseph Shuttleworth <[email protected]> wrote: > > > ----- Original Message ----- > From: Mark Carlson <[email protected]> > Date: Sunday, May 30, 2010 9:21 am > Subject: Re: [clug-talk] Need drivers > To: CLUG General <[email protected]> > >> Did you try 'ifconfig -a' to show all interfaces (including ones >> without IP addresses?) >> >> -Mark C. > > > Debian:~# ifconfig -a > > eth0 Link encap:Ethernet HWaddr 00:80:c6:fb:8f:16 > > BROADCAST MULTICAST MTU:1500 Metric:1 > > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > > collisions:0 txqueuelen:1000 > > RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) > > Interrupt:17 Base address:0xe800 > > > > eth3 Link encap:Ethernet HWaddr 00:a1:b0:10:7f:f1 > > UP BROADCAST MULTICAST MTU:1500 Metric:1 > > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > > collisions:0 txqueuelen:1000 > > RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) > > Interrupt:16 Base address:0xec00 > > lo Link encap:Local Loopback > > inet addr:127.0.0.1 Mask:255.0.0.0 > > inet6 addr: ::1/128 Scope:Host > > > > UP LOOPBACK RUNNING MTU:16436 Metric:1 > > RX packets:38 errors:0 dropped:0 overruns:0 frame:0 > > TX packets:38 errors:0 dropped:0 overruns:0 carrier:0 > > collisions:0 txqueuelen:0 > > RX bytes:2636 (2.5 KiB) TX bytes:2636 (2.5 KiB) > > > > I enabled eth0: > > ifconfig eth0 up > > changed /etc/network/interfaces: > > I can't get a connection on this either. > > ---------------------- > > # This file describes the network interfaces available on your system > > # and how to activate them. For more information, see interfaces(5). > > # The loopback network interface > > auto lo > > iface lo inet loopback > > # The primary network interface > > allow-hotplug eth0 > > iface eth0 inet dhcp > > hostname Debian > > _______________________________________________ > clug-talk mailing list > [email protected] > http://clug.ca/mailman/listinfo/clug-talk_clug.ca > Mailing List Guidelines (http://clug.ca/ml_guidelines.php) > **Please remove these lines when replying > _______________________________________________ clug-talk mailing list [email protected] http://clug.ca/mailman/listinfo/clug-talk_clug.ca Mailing List Guidelines (http://clug.ca/ml_guidelines.php) **Please remove these lines when replying
