aaron_wri...@selinc.com wrote:
Bill,
I think you were right. I took a hard look at my SDK paths and
changed a capital "I" to a lower-case "i" and everything seems better.
Thanks for help.
On a side note, perhaps "assuming" x64 when x86 fails is a bad
algorithm, or at least confusing.
Yeah, that most likely should be fixed.... :)
It is a bit of a chicken and the egg problem. At the point it tries to
figure this out, the compiler has not yet been fully determined so the
normal try compile stuff can not be used.
-Bill
_______________________________________________
Powered by www.kitware.com
Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html
Please keep messages on-topic and check the CMake FAQ at:
http://www.cmake.org/Wiki/CMake_FAQ
Follow this link to subscribe/unsubscribe:
http://www.cmake.org/mailman/listinfo/cmake
