Dave I replaced the cutlass bearing on my 29-2 two years ago and removed the Gori a couple of weeks ago. A couple of observations:
1. I found it difficult it impossible to use a normal prop puller to remove the hub after the blades were removed. I would have needed a much longer bolt in the prop puller than was standard. Given the Gori was shot, I opted to cut the hub so the prop puller would work. 2. Once the prop is removed I don't see how it will be possible to remove and replace the cutlass bearing with the shaft in place. If you have that figured out, great. If not you may need to think about leaving the prop in place and pulling the shaft. Good luck Martin Recalculating C&C 29-2 Toronto From: sthom...@sympatico.ca [mailto:sthom...@sympatico.ca] Sent: Monday, April 21, 2014 2:51 PM To: Stews List Subject: Re: Stus-List How to remove blades of gori 2-blade prop The pins that hold the blades are tapered stainless steel. Once you have removed the set screws, they should be easy to drive out, but make certain that you have all of the set screws removed. Mine had 2 short set screws in each hole, one on top of the other. Steve Thomas C&C27 MKIII Port Stanley, ON > Date: Mon, 21 Apr 2014 15:35:16 -0300 > From: dl...@ap.stmarys.ca <mailto:dl...@ap.stmarys.ca> > To: cnc-list@cnc-list.com <mailto:cnc-list@cnc-list.com> > Subject: Stus-List How to remove blades of gori 2-blade prop > > I have a C&C 29-2 (1983) with a 2-blade Gori prop on it. I need to > remove the prop to replace the cutless bearing (without removing the > whole shaft). The blades have to be removed in order to get access to > the nut that would allow the prop to be removed. Does anyone know how to > do this or know where instructions are online? I have been able to loose > the three set-screws in the prop. > > --- Dave > S/V "Vela" > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com <mailto:CnC-List@cnc-list.com>
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
