Thanks Steve and Alan.
I will look for the second set of set screws, as taking out the first
set did not appear to loosen anything. If the tapered pins don't wiggle
out, I'm not sure where they could be tapped out from as the inside send
of the pin is not accessible.
--- Dave
On 21/04/2014 3:50 PM, sthom...@sympatico.ca wrote:
The pins that hold the blades are tapered stainless steel. Once you
have removed the set screws, they should be easy to drive out, but
make certain that you have all of the set screws removed. Mine had
2 short set screws in each hole, one on top of the other.
Steve Thomas
C&C27 MKIII
Port Stanley, ON
> Date: Mon, 21 Apr 2014 15:35:16 -0300
> From: dl...@ap.stmarys.ca
> To: cnc-list@cnc-list.com
> Subject: Stus-List How to remove blades of gori 2-blade prop
>
> I have a C&C 29-2 (1983) with a 2-blade Gori prop on it. I need to
> remove the prop to replace the cutless bearing (without removing the
> whole shaft). The blades have to be removed in order to get access to
> the nut that would allow the prop to be removed. Does anyone know
how to
> do this or know where instructions are online? I have been able to
loose
> the three set-screws in the prop.
>
> --- Dave
> S/V "Vela"
>
> _______________________________________________
> This List is provided by the C&C Photo Album
> http://www.cncphotoalbum.com
> CnC-List@cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com