On my 35 I put the compass in the aft end of the quarter berth and the fluxgate in the wet locker.
Joel On Tuesday, June 3, 2014, Danny Haughey via CnC-List <cnc-list@cnc-list.com> wrote: > I installed the X5 with a p70 head unit last year and installed the flux > gate in the L shaped settee, low and near the center just aft of the head. > I still haven't got the stupid thing working however... > > > ---------- Original Message ---------- > From: dwight via CnC-List <cnc-list@cnc-list.com > <javascript:_e(%7B%7D,'cvml','cnc-list@cnc-list.com');>> > To: "'Steven Winks'" <swi...@cogeco.ca > <javascript:_e(%7B%7D,'cvml','swi...@cogeco.ca');>>, < > cnc-list@cnc-list.com > <javascript:_e(%7B%7D,'cvml','cnc-list@cnc-list.com');>> > Subject: Re: Stus-List Raymarine X5 auto pilot installation C&C 34+ > Date: Tue, 3 Jun 2014 10:14:48 -0300 > > > > I have my fluxgate compass mounted low in the boat just after of the mast > under the settee near center line…I have the control computer mounted in a > pod on the Binnacle guard…same pod also has my gps chartplotter…I find > these to be good locations on my 35 MKII…I like to have the control where I > can see rudder angle and heading, a remote control would be useful at times > but I do not have one and there is little to interfere with the compass in > that location…mine is an ST 4000 MKII plus, not that much different than > the newer X5 > > > ------------------------------ > > *From:* CnC-List [mailto:cnc-list-boun...@cnc-list.com > <javascript:_e(%7B%7D,'cvml','cnc-list-boun...@cnc-list.com');>] *On > Behalf Of *Steven Winks via CnC-List > *Sent:* June 3, 2014 10:03 AM > *To:* cnc-list@cnc-list.com > <javascript:_e(%7B%7D,'cvml','cnc-list@cnc-list.com');> > *Subject:* Stus-List Raymarine X5 auto pilot installation C&C 34+ > > > > Hi. I am planning to install a Raymarine X5 wheel pilot in my C&C 34+. > Does anyone have any advice on where best to install the computer and flux > gate compass? > > > > Thanks for any help. > > > > Steve Winks > > Corsair VI > > 1990 C&C 34+ > > Midland, ON > -- Joel 301 541 8551
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com