This is good to hear! One other spot we noticed was where the top of the engine compartment meets the bottom of the cockpit. Creaking happened there when we were headed upwind as well. Is this another area with “natural” flex for others?
-- Andrew Means S.V. Safari - 1977 C&C 34 Mk I Seattle, WA On June 27, 2016 at 5:54:22 PM, John and Maryann Read via CnC-List ( cnc-list@cnc-list.com) wrote: Hi Andrew As near as we can tell, the upper bulkhead is not bonded to the deck – and for a reason. C&C’s do flex a bit as they sail – especially as they bash to windward. The lack of this bond allows this flex to happen – all well and good as the stresses are dispersed throughout the entire hull. That said, the flex is moderated / controlled by a stainless “T” tang that is attached by bolts through the deck and also through the bulkhead. Ours was leaking a bit which we fixed by rebedding in butyl. Your photos seem to show a glue used to affix the head liner (not the deck) to the bulkhead has failed but do not think it is of great concern as was not structural in the first place. Overall, a noteworthy observation of minimal consequence so go sailing and have some fun John and Maryann Legacy III 1982 C&C 34 Noank, CT *From:* CnC-List [mailto:cnc-list-boun...@cnc-list.com] *On Behalf Of *Andrew Means via CnC-List *Sent:* Monday, June 27, 2016 5:15 PM *To:* cnc-list@cnc-list.com *Cc:* Andrew Means *Subject:* Stus-List Bulkheads separated from cabin top (C&C 34) Hey all - Last week while S.V. Safari was bashing upwind offshore en route to Tofino BC I noticed that the forward bulkheads were creaking. Upon closer inspection I realized that they had separated entirely from the cabin top by moving inboard about 1.5cm. Here’s the port bulkhead: http://imgur.com/Meqa58I And here’s the starboard: http://imgur.com/MIZHoiG The ends of both bulkheads are prevented from moving farther inward by the termination of the slots in the fiberglass ceiling that they’re nested in. You can see in the photos that they were at one point glued in. The bottoms of the bulkheads seem to be very well fiberglassed in to the hull, and there’s no sign of breakage along the lower parts. The bulkheads that form the forward walls of the hanging locker and bathroom are also separated too, by what looks like the same amount. Looking at previous photos it looks like they’ve been like this since before we bought the boat. They’re not loose at all, they seem very well set in place. Questions: 1. Is this a common problem? 2. How in the world would we fix this? 3. How critical is it to fix this immediately? Were we courting disaster to push the boat hard offshore? -- Andrew Means S.V. Safari - 1977 C&C 34 Mk I Seattle, WA <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient&utm_term=icon> Virus-free. www.avast.com <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient&utm_term=link> _______________________________________________ This list is supported by the generous donations of our members. If you like what we do, please help us pay for our costs by donating. All Contributions are greatly appreciated!
_______________________________________________ This list is supported by the generous donations of our members. If you like what we do, please help us pay for our costs by donating. All Contributions are greatly appreciated!