On Mon, May 15, 2017 at 8:36 AM, Joel Aronson via CnC-List < cnc-list@cnc-list.com> wrote:
> Same issue. Had to run the wire up from inside the anchor locker through > the pulpit and grab the end. It would not feed through the deck when I > tried it the other way. I've removed/replaced several pulpits. The hole in the deck is usually smaller than the pulpit tube diameter. Also, I've seen pulpit flanges with holes that are smaller than the tube diameter. In either case, feeding the wire down is not a percentage shot. The wire will hit the deck or flange lip. I've been able to use the old wire to pull a messenger and feed it that way but more often that not I'll either feed it up through the deck or unfasten and lift that pulpit leg for access. Dennis C. Touche' 35-1 #83 Mandeville, LA
_______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated!
