I used the old wire to pull the new! It may have been dumb luck though! Sometimes even I get some dumb luck! Rick Paikea 37/40 Friday Harbor until 10:00 today and then off to Orcas.
Rick Rohwer 509 306 1094 > On Aug 9, 2017, at 06:24, Joel Aronson via CnC-List <cnc-list@cnc-list.com> > wrote: > > It is a PIA job! I manged to feed the wire from the bottom and grab the end > of the wire with needle nose pliers at the exit hole. > > Spray the wire with McLube. It will feed easier. > > Joel > >> On Wed, Aug 9, 2017 at 8:53 AM, David via CnC-List <cnc-list@cnc-list.com> >> wrote: >> So I am trying to replace the bow light wire in the pulpit. Tried to work >> the wire from both ends. Nuthin. Popped the pulpit leg where wire exits >> thru deck and it looks like a feeder tube thru the deck to lead the wire. >> It seems I need to remove the whole pulpit to feed a new wire. >> >> Am I missing something? >> >> Thanks in advance. >> >> 1981 40-2. >> >> >> >> Sent from my Verizon 4G LTE smartphone >> >> _______________________________________________ >> >> This list is supported by the generous donations of our members. If you wish >> to make a contribution to offset our costs, please go to: >> https://www.paypal.me/stumurray >> >> All Contributions are greatly appreciated! >> > > > > -- > Joel > 301 541 8551 > _______________________________________________ > > This list is supported by the generous donations of our members. If you wish > to make a contribution to offset our costs, please go to: > https://www.paypal.me/stumurray > > All Contributions are greatly appreciated!
_______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated!