I was able to connect my cheap Daisy2 AIS receiver to my onboard PC via USB. And my plotter via 183.
Lots of targets around Annapolis! Joel On Tue, Dec 19, 2017 at 1:13 PM Frederick G Street via CnC-List < cnc-list@cnc-list.com> wrote: > I don’t know of any gear that even supports AIS over 4800; everything > requires 38400 baud. > > > Fred Street -- Minneapolis > S/V Oceanis (1979 C&C Landfall 38) -- on the hard in Bayfield, WI :^( > > On Dec 19, 2017, at 12:04 PM, Della Barba, Joe via CnC-List < > cnc-list@cnc-list.com> wrote: > > Yes it does. If you have a lot of AIS targets they will totally overload a > 4800 baud channel. > The plotter goes off to SH tomorrow. $35 to upgrade the firmware and $15 > more to wipe the MMSI from one of my old VHFs. I have to say Standard > Horizon is doing well by me today J > Also props to MilltechMarine. I had one of their AIS receivers for years > and it has migrated to another C&C lately. > > Joe > Coquina > > > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > > -- Joel 301 541 8551
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray