I see the screws in the side of the mast. Your mast step may extend up into the base of the mast and is held by those screws. Is there access to those screws on the other side of the mast?
If you remove only the 4 hex heads that hold the step plate down the question becomes will the step plate fit through the deck? Wouldn't hurt to remove the screws in the side of the mast and see if the extrusion slides off the step plate. Dennis C. On Sat, Jun 1, 2019 at 5:04 AM Dan via CnC-List <cnc-list@cnc-list.com> wrote: > Hi all, > I have a C&C44 and I'm removing my mast this afternoon for the first time > (my first time) and I've accessed the mast step (keel stepped mast) > > There are a few screws/bolts going right around the base of the mast close > to the stepping point. I'm wonderring if these screws have to be removed in > order to pull the mast out? are the securing the mast to the mast step? > > Here is a photo: > > > https://drive.google.com/open?id=0B0TmWprZksmUa0o2eUZ0V1pabGpLaDRpeFJBOVozenJwNTFn > > Dan Cormier > Breakaweigh I > C&C44 > Halifax, NS > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > >
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
