I believe so. I used the openocd.cfg that is given on the wiki. I've even followed the steps here: http://svn.openmoko.org/developers/werner/notes/openocd which seem to be legit. The step I get stuck on is running openocd. I think maybe there is something wrong with the libftdi phase? I'm not sure why I think that though. I just think that because I'm installing that by hand as opposed to sudo apt-getting it. Is there a way to check that openocd will use libftdi?
Lynn On 8/10/08, Neng-Yu Tu (Tony Tu) <[EMAIL PROTECTED]> wrote: > > Hi Lynn- > > > Hi all, > > > > I was wondering, has anyone had any luck connecting their debug board > > (v3) to a neo1973? I followed all the instructions here: > > http://wiki.openmoko.org/wiki/Debug_Board_v3 (for linux) > > but I keep getting 'no valid jtag interface found'. But that doesn't > > make any sense because I can see the debug board from my laptop when i > > do 'lsusb'. Any ideas? Thanks! > > > > Lynn > > > > > > > Does your openocd using correct setting file? v3 board could connect to > neo1973, because it basically compatible old boards. > > -- > Tony Tu (Neng-Yu Tu) > Openmoko, Inc. > Support. > > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community >
_______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community