-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hi Lynn-
> I was wondering if anyone was using the Neo1973 (GTA01v4) with Debug > board v3. I used the openocd.cfg available on the wiki and I get this > problem: > Info: openocd.c:82 main(): Open On-Chip Debugger (2006-08-01 12:00 CEST) > Info: configuration.c:50 configuration_output_handler(): Command > ft2232_device_desc not found > Info: configuration.c:50 configuration_output_handler(): Command > ft2232_layout not found > Info: configuration.c:50 configuration_output_handler(): Command > ft2232_vid_pid not found > Error: jtag.c:1219 jtag_init(): No valid jtag interface found (ft2232) > > It seems like openocd is having some trouble with ft2232 because I don't > see anything wrong with those commands. > Does your openocd load neo1973 specific config? like tmp/openocd -f tmp/openocd-debugv2.cfg Usually it is because your USB vid/pid setting is not correct in the config file(load the wrong config file) Hope this helps. = - -- Neng-Yu Tu (Tony Tu) Openmoko, Inc. Support. Some questions could be answered by reference following link: Wiki - http://wiki.openmoko.org Download - http://downloads.openmoko.org Freerunner Introduction - http://wiki.openmoko.org/wiki/Getting_Started_with_your_Neo_FreeRunner -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.9 (MingW32) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iEYEARECAAYFAki7c4MACgkQmV6sZhhBn29BwQCfSRPiSVTPKhPeUAGd1R6m0D80 1sIAn1dFiXdIuulTTCqYM6mmfPsRvjJD =ubFB -----END PGP SIGNATURE----- _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community