the wiki posted solution was tested by myself on a the currebt debian and did work! Are you using the same environment?
Cheers Tony On Thu, Nov 6, 2008 at 10:46 AM, Denis Johnson <[EMAIL PROTECTED]>wrote: > I have had this setting for months it does not work for me. > > Whenever I want to connect my FR, I must first plug it in into the usb > and then run the following script which someone once posted here or on > the #openmoko irc. Until I run ths script I cannot ping and hence ssh > into the FR. Unfortunately I don't know enough to integrate and > automate what the script does into my interfaces file. If someone can > shed some more light, it would be appreciated: > > ---------------------------------- > #!/bin/sh > # Enables Hostside USB-Networking for neo > ifconfig usb0 down > ifconfig usb0 192.168.0.200 netmask 255.255.255.0 up > iptables -A POSTROUTING -t nat -j MASQUERADE -s 192.168.0.0/24 > echo 1 > /proc/sys/net/ipv4/ip_forward > iptables -P FORWARD ACCEPT > route add -host 192.168.0.202 gw 192.168.0.200 > route -n | grep -e "Destination" -e "usb0" > ---------------------------------- > > cheers Denis > > On Thu, Nov 6, 2008 at 7:13 AM, joezeewails <[EMAIL PROTECTED]> wrote: > > > > Stefan Monnier wrote: > > > > > > That's probably not right. You probably want to try "allow-hotplug > > > ubs0" instead. "auto" means to do it at boot time and it may just fail > > > if (for some reason) the usb0 interface is not yet created. > > > > > > > > > Stefan > > > > > I could confirm this. > > It doesn't work with "auto usb0" with "allow-hotplug usb0" it works just > > fine. > > Every time I plug the Freerunner in my debian etch it brings the > > interface up. > > I use the version from the wiki with a extra freerunner script. > > > > My entry in /etc/network/interfaces: > > > > #freerunner > > allow-hotplug usb0 > > iface usb0 inet static > > address 192.168.0.200 > > netmask 255.255.255.0 > > post-up /etc/network/freerunner start > > pre-down /etc/network/freerunner stop > > > > > > > > Someone should correct the wiki, should I? > > > > > > Cheers, > > Joe > > > > > > _______________________________________________ > > Openmoko community mailing list > > community@lists.openmoko.org > > http://lists.openmoko.org/mailman/listinfo/community > > _______________________________________________ > Openmoko community mailing list > community@lists.openmoko.org > http://lists.openmoko.org/mailman/listinfo/community >
_______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community