QI > Make sure you have the "rw" in there, and the /boot/append-GTA02 is in > the partition with the rootfs. Try adding a space before the rw in case > I mangled it with recent changes. > > It's a bug I think if the rootfs does not remount root rw. >
the same failed to set owner root for /var/volatile/cache/ the same failed to set mode 0755 for /var/volatile/cache/ UBOOT > You need to escape the ; with backslashes. Your setenv is only setting > the text as far as the first ; as it stands, then taking the nand and > bootm as new commands and running them right away. I did the following: r...@x:~# chown uucp.uucp /dev/ttyACM0 r...@x:~# cu -l /dev/ttyACM0 GTA02v5 # setenv bootcmd setenv bootargs \${bootargs_base} \${mtdparts}\; nand read.e 0x32000000 kernel 0x300000\; bootm 0x32000000 GTA02v5 # saveenv Saving Environment to NAND... Erasing Nand...GTA02v5 # If I now choose boot from the bootloader it boots fine, But after a reboot I have to do the same again it, it doesn't save it. > What does > > ifconfig -a lo ... pan0 ... usb0 Link encap:Ethernet Hwaddr DA:DF:7E:17:08:9A UP BROADCAST RUNNING MULTICAST MTU:1500 Metrik:1 RX packets:17 errors:0 dropped:0 overruns:0 frame:0 TX packets:27 errors:0 dropped:0 overruns:0 carrier:0 Collisions:0 txqueuelen:1000 RX bytes:9792 (9.7 KB) TX bytes:4140 (4.1 KB) > route -n Kernel-IP-routingtable Dest Gateway Genmask Flags Metric Ref Use Iface > say? dmesg on the PC side? [23821.176092] usb 1-1: new full speed USB device using uhci_hcd and address 108 [23821.384140] usb 1-1: configuration #1 chosen from 2 choices [23821.392754] usb0: register 'cdc_ether' at usb-0000:00:1a.0-1, CDC Ethernet Device, 9e:08:34:97:d5:f8 [23834.084104] usb0: no IPv6 routers present Thanks again for helping regards Michael _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community