On Thu, Mar 05, 2009 at 10:25:40AM +0300, Paul Fertser wrote: > > All this steps except starting fluid.exe are not strictly necessary > and i'd recommend to start fluid like that: > > FLUID_PORT=/dev/ttySAC0 fluid.exe -oo -od13,13 -f <path_to_moko11_bin> > > Notice i use ROM bootloader and moko11 firmware.
I flashed the moko11 GSM firmware today and found the same thing: -oo without FLUID_FLOWCONTROL works. I couldn't not get any of the other combinations to work. I first backed up the old firmware, then flashed the new one: # time FLUID_PORT=/dev/ttySAC0 fluid.exe -oo -r 0x00000000..0x00400000 -f ~rask/download/firmware/calypso-firmware-backup.m0 (real 6m28.286s user 0m11.200s sys 0m4.315s) # time FLUID_PORT=/dev/ttySAC0 fluid.exe -oo -f ~rask/download/firmware/calypso-moko11.m0 (real 2m56.764s user 0m16.070s sys 0m0.990s) I did need two power off/on cycles between the two fluid invocations, though. I did not use "s3c24xx-gpio b7=0" as according to the schematics, pin GPIOB7 is just the MODEM_ON signal. -- Rask Ingemann Lambertsen Danish law requires addresses in e-mail to be logged and stored for a year _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community