Rask Ingemann Lambertsen <r...@sygehus.dk> writes: > I did need two power off/on cycles between the two fluid invocations, > though.
I found by experimentation that with -od13,13 fluid was able to connect to the bootloader every time i tried power-cycling. But yes, without it it's like 1 out of 20 when it fails. > I did not use "s3c24xx-gpio b7=0" as according to the schematics, > pin GPIOB7 is just the MODEM_ON signal. And that MODEM_ON is a push-button (literally). Looks like every time it's "pressed" for like 200ms the modem restarts (or starts if it wasn't powered before). "Pressing" is transition from b7=0 to b7=1. BTW, modem reset line is not connected on GTA02. With any new kernel all that gpio pmu tricks are not necessary anymore (at least on GTA02) as it reliably powers off/on the modem if you use sysfs interface. -- Be free, use free (http://www.gnu.org/philosophy/free-sw.html) software! mailto:fercer...@gmail.com _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community
