On Wed, Aug 12, 2009 at 03:04:26PM +0400, Paul Fertser wrote: > Rui Miguel Silva Seabra <r...@1407.org> writes: > > On Wed, Aug 12, 2009 at 12:56:26PM +0400, Paul Fertser wrote: > >> Bernhard Reiter <ock...@raz.or.at> writes: > >> > CTRL-EVENT-SCAN-RESULTS > >> > Trying to associate with <mac address> (SSID='<SSID>' freq=2437 MHz) > >> > Associated with <mac address> > >> > WPA: Key negotiation completed with <mac address> [PTK=CCMP GTK=TKIP] > >> > CTRL-EVENT-CONNECTED - Connection to <mac address> completed (auth) > >> > [id=0 id_str=] > >> > > >> > But unfortunately, I still can't ping my router, nor can I ping the > >> > FreeRunner from my laptop either. > >> > >> You're supposed to somehow set IP for eth0 after that (usually with > >> the help of DHCP client). I really wonder why it's not obvious :S > > > > You're also supposed to have an SSID setup before using a DHCP client. > > > > At least for me that NEVER happens :| > > wpa_supplicant does that for you. I'm yet to see a single case when it > couldn't.
Somehow people keep missing the point... With Mokonnect that NEVER happens. Wifi works just fine, Mofi sets it up without a problem. I'm quite sure wpa_supplicat hand made config will work as well. > >> Also some APs require "wmiconfig -ieth0 --power=maxperf" trick to > >> work. > > > > I always run that. > > Eats battery like mad. I suggest using this only as a last resort. I know, it lasted two hours last I tried, but at least it's reliable :) Rui _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community