On Tuesday, September 18, 2012 12:33:46 PM robin wrote: > thanks as always for the work! > > I have one issue with the new alarm turning into vibrate only after 60 > secs: > > If I put an alarm and turn the phone completely oft (GTA02 SD-card version) > the phone starts nicely to boot at the right time, but now the boot time is > about 75 secs, so once everything has been initiated the phone starts to > vibrate for the alarm but there is now place to turn the alarm off.
Interesting - i didnt know that rtc alarm can power on the device. I just tested the alarm with suspend to ram, which seems to be working perfectly now... > in my opinion the alarm should only start once the interface to press > snooze or cancel the alarm is present, and maybe we give it even two > seconds of silence before it starts (eg you sit somewhere where everyone > else is quite, you see the alarm go off but it doesn't ring yet and you > can still press cancel before the alarm goes off properly). Sure this would be nice... > a very very > advanced version of the alarm could have a box to type in the delay > seconds for booting until the alarm is actually present which would be > taken into account so that the alarm would actually ring at the right time > and not one to two minutes later. This could be done. Maybe pressing "Power off" could reschedule the RTC a bit. But this is really advanced, i wonder if other phones could do something like this... Btw dont count very much with me on implementing these. I got some other tasks on my list. I have QtMoko with Qt 4.8.3 working now, but it displays .pic icons with wrongs sizes - if anyone has idea what could be wrong it would be welcome. Regards Radek _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community