http://qa.mandrakesoft.com/show_bug.cgi?id=509
[EMAIL PROTECTED] changed:
What |Removed |Added
----------------------------------------------------------------------------
AssignedTo|[EMAIL PROTECTED] |[EMAIL PROTECTED]
------- Additional Comments From [EMAIL PROTECTED] 2003-07-09 01:22 -------
this should be fine with current kernel
--
Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
------- Reminder: -------
assigned_to: [EMAIL PROTECTED]
status: NEW
creation_date:
description:
The intel motherboards with the ICH4 controller have severe problems with kernel
2.4.19.16mdk.
a) On boot up, the message
PCI: Device 00:1f.1 not available because of resource collisions
The relevant sections from dmesg are
....
The first reference to 00:1f.1
PCI: PCI BIOS revision 2.10 entry at 0xf0031, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router PIIX [8086/24c0] at 00:1f.0
PCI: Found IRQ 9 for device 00:1f.1
PCI: Sharing IRQ 9 with 00:1d.2
.....Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH4: IDE controller on PCI bus 00 dev f9
PCI: Device 00:1f.1 not available because of resource collisions
ICH4: (ide_setup_pci_device:) Could not enable device.
hda: Maxtor 91531U3, ATA DISK drive
hdb: ST340016A, ATA DISK drive
hdc: HL-DT-ST CD-ROM GCR-8520B, ATAPI CD/DVD-ROM drive
hdd: HITACHI DVD-ROM GD-2000, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
lspci gives
...
00:1f.0 ISA bridge: Intel Corp.: Unknown device 24c0 (rev 01)
00:1f.1 IDE interface: Intel Corp. 82801DB ICH4 IDE (rev 01)
00:1f.3 SMBus: Intel Corp.: Unknown device 24c3 (rev 01)
...
b) trying to start up dma does not work.
hdparm /dev/hda
/dev/hda:
multcount = 16 (on)
IO_support = 0 (default 16-bit)
unmaskirq = 0 (off)
using_dma = 0 (off)
keepsettings = 0 (off)
readonly = 0 (off)
readahead = 8 (on)
geometry = 1868/255/63, sectors = 30015216, start = 0
]>hdparm -d1 /dev/hda
/dev/hda:
setting using_dma to 1 (on)
HDIO_SET_DMA failed: Operation not permitted
using_dma = 0 (off)
The disks are very slow.
c) Sound does not work. The standare oss drivers do not load at all. -- error
that the codec cannot be intialised. The alsa drivers load fine, but again
no sound. (again using the onboard sound ICH4 sound card)
