http://qa.mandrakesoft.com/show_bug.cgi?id=509
------- Additional Comments From [EMAIL PROTECTED] 2003-17-09 15:06 ------- Mdk9.2rc2: The chip sound is detected during a fresh install. After some settings in kmix, the sound works fine. -- Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: NEW creation_date: description: The intel motherboards with the ICH4 controller have severe problems with kernel 2.4.19.16mdk. a) On boot up, the message PCI: Device 00:1f.1 not available because of resource collisions The relevant sections from dmesg are .... The first reference to 00:1f.1 PCI: PCI BIOS revision 2.10 entry at 0xf0031, last bus=2 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Using IRQ router PIIX [8086/24c0] at 00:1f.0 PCI: Found IRQ 9 for device 00:1f.1 PCI: Sharing IRQ 9 with 00:1d.2 .....Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH4: IDE controller on PCI bus 00 dev f9 PCI: Device 00:1f.1 not available because of resource collisions ICH4: (ide_setup_pci_device:) Could not enable device. hda: Maxtor 91531U3, ATA DISK drive hdb: ST340016A, ATA DISK drive hdc: HL-DT-ST CD-ROM GCR-8520B, ATAPI CD/DVD-ROM drive hdd: HITACHI DVD-ROM GD-2000, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 lspci gives ... 00:1f.0 ISA bridge: Intel Corp.: Unknown device 24c0 (rev 01) 00:1f.1 IDE interface: Intel Corp. 82801DB ICH4 IDE (rev 01) 00:1f.3 SMBus: Intel Corp.: Unknown device 24c3 (rev 01) ... b) trying to start up dma does not work. hdparm /dev/hda /dev/hda: multcount = 16 (on) IO_support = 0 (default 16-bit) unmaskirq = 0 (off) using_dma = 0 (off) keepsettings = 0 (off) readonly = 0 (off) readahead = 8 (on) geometry = 1868/255/63, sectors = 30015216, start = 0 ]>hdparm -d1 /dev/hda /dev/hda: setting using_dma to 1 (on) HDIO_SET_DMA failed: Operation not permitted using_dma = 0 (off) The disks are very slow. c) Sound does not work. The standare oss drivers do not load at all. -- error that the codec cannot be intialised. The alsa drivers load fine, but again no sound. (again using the onboard sound ICH4 sound card)