On Tue, 2003-09-09 at 19:09, Byron Poland wrote:
> RC2 installed fine on my 120 gig Seagate SATA drive, on an Silicon Image
> SATA controller, that is on my asus nforce2 mb
>
> from lspcidrake:
>
> Silicon Image|Sil3112A Serial ATA [STORAGE_RAID]
>
> hdparm -i /dev/hde
>
> /dev/hde:
>
> Model=ST3120026AS, FwRev=3.05, SerialNo=3JT0JJKQ
> Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
> RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
> BuffType=unknown, BuffSize=8192kB, MaxMultSect=16, MultSect=16
> CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=234441648
> IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
> PIO modes: pio0 pio1 pio2 pio3 pio4
> DMA modes: mdma0 mdma1 mdma2
> UDMA modes: udma0 udma1 udma2
> AdvancedPM=no WriteCache=enabled
> Drive conforms to: ATA/ATAPI-6 T13 1410D revision 2:
>
> * signifies the current active mode
>
Was the drive blank when you began? Was/is it the only hard drive
(including normal IDE HD's) in the system? Right now I'm attempting to
determine what is different about my system now that it doesn't like it.
Other than the size difference, that does look like my setup.
Thanks!
