> > > > > > > > > > > > -- Geoff. > > > > Where would I put that, Geoff? I have to go into the > > /usr/src/RPM/BUILD/libraw1394-0.9.0 directory and mess around in there? I > > can recompile kernel src rpms but not this package. It apparently crashes > > in the make process while doing checks. I did a little searching and was > > wondering will I have to change info in the file config.guess? I tried > > rebuiding with target i686 but that didn't help neither. I have no idea > > what to do in this situation. This is a first for me. Without this lib > > being built, I can not use the SB1394 port on my Audigy card or my new pci > > firewire card that I bought. All this so that I can use a new firewire > > webcam , Orange IBot. Save me someone as I only get this error with > > libraw1394. Should I try an older source to see if that would work? >
inside the spec file. replace %configure with %configure2_5x anyway I tested this on the compile box, it built fine without any changes. > I just thought about this but should I remove the SB Audigy and my IEEE1394 > PCI card first before installing libraw1394? I had searched on the web and > the method that they show for installing the tarball requires me to have the > hardware installed after installing the package. Here is the link: > Hmm, no, I don't see why you need to rip out your card before you compile software? BTW: why are you rebuilding? binaries should be available .. -- Geoff.