On Wed, Nov 5, 2008 at 8:09 PM, Marc Jones <[EMAIL PROTECTED]> wrote: > I see the problem. It is interesting that in some situations that it works. > > Marc > > > -- > Marc Jones > Senior Firmware Engineer > (970) 226-9684 Office > mailto:[EMAIL PROTECTED] > http://www.amd.com/embeddedprocessors > > LPC serial IRQs were being left enabled when there is no LPC serial device. > > Signed-off-by: Marc Jones <[EMAIL PROTECTED]> > > > Index: mainboard/pcengines/alix2c3/dts > =================================================================== > --- mainboard/pcengines/alix2c3/dts (revision 980) > +++ mainboard/pcengines/alix2c3/dts (working copy) > @@ -34,9 +34,9 @@ > /config/("southbridge/amd/cs5536/dts"); > /* Interrupt enables for LPC bus. > * Each bit is an IRQ 0-15. */ > - lpc_serirq_enable = "0x0000105A"; > + lpc_serirq_enable = "0x00001002"; > /* LPC IRQ polarity. Each bit is an IRQ 0-15. */ > - lpc_serirq_polarity = "0x0000EFA5"; > + lpc_serirq_polarity = "0x0000EFFD"; > /* 0:continuous 1:quiet */ > lpc_serirq_mode = "1"; > /* GPIO(0-0x20) for INT D:C:B:A, 0xFF=none. > >
tried this with my mods but didn't work will try a clean build now.. Roman -- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
