Hi Matt,
Did you see this old thread?
https://www.mail-archive.com/[email protected]/msg51097.html
I have and AM1I-A too and I had some problems at the beginning..
Regards,
Eli
On 08/12/2019 19:43, Matt B wrote:
Hi,
In the spirit of board report coverage, I pulled out the (used, but
new to me) AM1I-A I have and spent a day or two trying to install the
latest coreboot on it.
The board boots fine under the stock bios, and returns to working
order if flashed with my backup, but shows little signs of life with
coreboot.
Along the way I extracted and included the vgabios rom, as well as
tried with a nivida card, so I'm pretty sure that's not it.
I tried having it save the console output to flash, but that made the
build fail. [1]
Yesterday evening I noticed it was configured by default to use
open-source init (and for some reason the build finishes without
error), but as far as I know that doesn't exist for family 16h.
Switching to BinaryPI causes the build to fail. [2] 3rd party blobs
are cloned and enabled.
I'm running an Athlon 5250, or something of that nature, with a couple
of gigs of ram on one dimm. My current .config is [3].
Sincerely,
-Matt
[1] https://pastebin.com/FZEiCq8P
[2] https://pastebin.com/Q30u7Lgs
[3] https://pastebin.com/ufuq22i8
_______________________________________________
coreboot mailing list -- [email protected]
To unsubscribe send an email to [email protected]
_______________________________________________
coreboot mailing list -- [email protected]
To unsubscribe send an email to [email protected]
