On Sun, Aug 10, 2008 at 11:29:11AM +0200, Bram wrote: > Citeren Nicholas Clark <[EMAIL PROTECTED]>:
> >By default, does Test::Smoke run the tests using ./TEST, and then only > >re-run > >with ./harness if tests fail? Or does it now use Test::Harness first time? > > That depends on the configuration of the smoke. > > During the configuration the question is asked: > > 'Use harness only (skip TEST)?' > > If you answer n then ./TEST is run and if there is a failure then > ./harness is run. > Smokes that are configured like this and run a blead smoke (with > Test::Smoke 1.33) will show FAIL(X) and the failures won't be visible. > (assuming there was a failure). > > If you answer y then only ./harness is run. > Smokes that are configured like this and run a blead smoke (with > Test::Smoke 1.33) will show PASS-so-far and the failures won't be > visible. (assuming there was a failure). Ah right. So anyone using harness can now enjoy the speed up from setting TEST_JOBS in their environment? > Everyone running a blead smoke should upgrade Test::Smoke. At least, they can if they upgrade? Nicholas Clark