Citeren Nicholas Clark <[EMAIL PROTECTED]>:
On Sun, Aug 10, 2008 at 11:29:11AM +0200, Bram wrote:
Citeren Nicholas Clark <[EMAIL PROTECTED]>:
>By default, does Test::Smoke run the tests using ./TEST, and then only
>re-run
>with ./harness if tests fail? Or does it now use Test::Harness first time?
That depends on the configuration of the smoke.
During the configuration the question is asked:
'Use harness only (skip TEST)?'
If you answer n then ./TEST is run and if there is a failure then
./harness is run.
Smokes that are configured like this and run a blead smoke (with
Test::Smoke 1.33) will show FAIL(X) and the failures won't be visible.
(assuming there was a failure).
If you answer y then only ./harness is run.
Smokes that are configured like this and run a blead smoke (with
Test::Smoke 1.33) will show PASS-so-far and the failures won't be
visible. (assuming there was a failure).
Ah right. So anyone using harness can now enjoy the speed up from setting
TEST_JOBS in their environment?
Correct.
Or if 'Extra options for Test::Harness 3 (HARNESS_OPTIONS)' during
smoke configuration is/was set to j5 (were 5 is the number of jobs)
Kind regards,
Bram