You seem to have an old u-boot, so the solution is to upgrade your u-boot. If for some reason you cannot, Search the archives for my machine-number patch which allows the kernel to boot with the older u-boot.
Kevin > I downloaded the git sources by using > git-clone git://source.mvista.com/git/linux-davinci-2.6.git > i ran ARCH=arm CROSS_COMPILE=arm_v5t_le- make distclean > then ARCH=arm CROSS_COMPILE=arm_v5t_le- make > davinci_evm_dm644x_defconfig > then ARCH=arm CROSS_COMPILE=arm_v5t_le- make uImage > I am using the Montavista compilation tools from Montavista's site. > I used tftpboot to boot off this image, and the board gets stuck after > "Uncompressing Linux ... done, booting the kernel." > I have only the ethernet, serial, and power cable plugged in. > > This board works fine when using the TI 2.6.10 kernel. > > Output: > > ## Booting image at 80700000 ... > Image Name: Linux-2.6.20-omap1-ge7255f31-dir > Image Type: ARM Linux Kernel Image (uncompressed) > Data Size: 1374944 Bytes = 1.3 MB > Load Address: 80008000 > Entry Point: 80008000 > Verifying Checksum ... OK > OK > > Starting kernel ... > > Uncompressing > Linux............................................................. > .............................. done, booting the kernel. > > Thanx for any help, > > Nachum Kanovsky > Senior Software/Hardware Engineer > Manager of Infrastructures > Mango DSP Ltd. > E-mail: [EMAIL PROTECTED] > Work: +972 2 588 5039 > Cell: +972 547 508 121 > > Favorite Quote: > Mal: "Well, my days of not taking you seriously are certainly coming to > a middle..." > _______________________________________________ > Davinci-linux-open-source mailing list > Davinci-linux-open-source@linux.davincidsp.com > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source