Kim, The safest thing to do is to set the S3 switch to 1100111110 which is UART mode. In this way the board will not boot anything that you might already have in the NAND flash. After you flash the board you should power it off and reset the S3 switch to 0000111110 to NAND boot. Also make sure that your J4 jumper is set to NAND. Please let me know if you need additional information.
Sincerely, Chase Maupin Software Applications Catalog DSP Products e-mail: [EMAIL PROTECTED] phone: (281) 274-3285 -----Original Message----- From: Kim Klaiman [mailto:[EMAIL PROTECTED] Sent: Tuesday, September 11, 2007 8:30 AM To: Maupin, Chase; [email protected] Subject: RE: Booting DaVinci EVM from NAND Flash Thank you very much Chase, It took some time, but now I have all those programs. I have another question regarding the loading process. Spraaa0 says on page 3 (http://focus.ti.com/lit/an/spraaa0/spraaa0.pdf): "Set S3 red switch (circled in green in Figure 1) to 0000111110" But there is another document - http://c6000.spectrumdigital.com/davincievm/revd/files/How_to_Flash_U-Bo ot_on_DaVinci_EVM.pdf which says on page 5: "Make sure the red S3 switch DIP positions 1 and 2 are set to ON" So which one is correct? Thanks again, Kim -----Original Message----- From: Maupin, Chase [mailto:[EMAIL PROTECTED] Sent: September 10, 2007 11:10 AM To: Kim Klaiman; [email protected] Subject: RE: Booting DaVinci EVM from NAND Flash Kim, You can find all three of these programs by going to www.ti.com/dvevmupdates. Create an account if you have not already done so and log in. From the main page select the DM644x DVEVM section. In the miscellaneous Components section at the bottom of the page there is a package called "restore_1_20_00_10.tar.gz". If you download this package and extract it there will be another .tar.gz package inside called Release_BinaryPackage.tar.gz. If you unpack that package inside are the flashwriter, ubl, and u-boot images you are looking for. You can also use the address below. This should take you directly to the restore package mentioned above. https://www-a.ti.com/extranet/cm/product/dvevmsw/dspswext/download/resto re_1_20_00_10.tar.gz Sincerely, Chase Maupin Software Applications Catalog DSP Products e-mail: [EMAIL PROTECTED] phone: (281) 274-3285 -----Original Message----- From: [EMAIL PROTECTED] om [mailto:[EMAIL PROTECTED] ncidsp.com] On Behalf Of Kim Klaiman Sent: Monday, September 10, 2007 9:57 AM To: [email protected] Subject: Booting DaVinci EVM from NAND Flash Hello all, "Booting DaVinci EVM from NAND Flash" (SPRAAA0) document requires ubl_nand.bin (14 KB first stage boot-loader), u-boot-567-nand.bin (second stage boot loader) and flashwriter_nand.out CCS program. Where can I get those programs? Thanks, Kim Klaiman _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
