On Tuesday 28 April 2009, Paulraj, Sandeep wrote: > Dave, > We can add such support/enhancements later. The > patch as such will work for sure.
OK, I can understand that. This board seems to have the most complex NAND config of the DaVinci EVMs. > In our LSPs we can use > only one NAND at a time. We do not at this point of time > have support even in the kernel where both NANDs can be > used at the same time. Its only either of the 2. And for that matter, even the DaVinci GIT tree doesn't yet support this board ... much less mainline Linux! I believe the current NAND driver (in 2.6.30-rc) should handle this fine, though. - Dave > Thanks, > Sandeep > > > -----Original Message----- > > From: David Brownell [mailto:davi...@pacbell.net] > > Sent: Tuesday, April 28, 2009 5:57 PM > > To: Paulraj, Sandeep; u-b...@lists.denx.de > > Cc: davinci-linux-open-source@linux.davincidsp.com > > Subject: Re: [PATCH] ARM DaVinci: Adding DM357 Support > > > > ... > > > > So this initial U-Boot support only supports the smaller of > > the two NAND chips, and access to the second one is only > > after booting to the operating system? > > > > I'd have liked to see the NAND driver updates needed to support > > the chipselect of the second NAND chip, and use it with HW ECC. > > > > - Dave > > > > > > > > _______________________________________________ Davinci-linux-open-source mailing list Davinci-linux-open-source@linux.davincidsp.com http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source