Thanks for the reply. Can you paste your /proc/crypto as well? Thanks, Jan
On Mon, Feb 15, 2016 at 11:25 AM, Rick Thomas <rbtho...@pobox.com> wrote: >> Here you go... >> >>> root@sheeva:~# rmmod mv_cesa >>> root@sheeva:~# modprobe marvell_cesa allhwsupport=1 >>> root@sheeva:~# dmesg | tail -n 20 >>> [ 16.730426] systemd[1]: Mounted Debug File System. >>> [ 16.756783] systemd[1]: Started Load Kernel Modules. >>> [ 16.776948] systemd[1]: Started Create list of required static device >>> nodes for the current kernel. >>> [ 16.804146] systemd[1]: Started LSB: Set console font and keymap. >>> [ 17.023950] systemd[1]: Started Journal Service. >>> [ 18.514731] EXT4-fs (dm-0): re-mounted. Opts: errors=remount-ro >>> [ 19.804133] orion_wdt: Initial timeout 21 sec >>> [ 19.848469] MV-CESA:Could not register sha1 driver >>> [ 19.848485] MV-CESA:Could not register hmac-sha1 driver >>> [ 20.379009] systemd-journald[180]: Received request to flush runtime >>> journal from PID 1 >>> [ 20.386082] sd 0:0:0:0: Attached scsi generic sg0 type 0 >>> [ 20.386886] ses 0:0:0:1: Attached scsi generic sg1 type 13 >>> [ 21.518406] EXT4-fs (mmcblk0p1): mounting ext2 file system using the >>> ext4 subsystem >>> [ 21.682097] EXT4-fs (mmcblk0p1): mounted filesystem without journal. >>> Opts: (null) >>> [ 22.402713] Adding 9764860k swap on /dev/mapper/sheeva-swap. >>> Priority:-1 extents:1 across:9764860k FS >>> [ 22.938703] EXT4-fs (dm-2): mounted filesystem with ordered data mode. >>> Opts: (null) >>> [ 23.631978] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready >>> [ 27.662122] mv643xx_eth_port mv643xx_eth_port.0 eth0: link up, 1000 >>> Mb/s, full duplex, flow control disabled >>> [ 27.662180] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready >>> [ 37.350057] warning: process `colord-sane' used the deprecated sysctl >>> system call with 8.1.2. >>> root@sheeva:~# uname -a >>> Linux sheeva 4.4.0-trunk-marvell #1 Debian 4.4.1-1~exp1 (2016-02-10) >>> armv5tel GNU/Linux >>> root@sheeva:~# >> >> For what it's worth, the system boots fine and appears to run OK with the >> 4.4 kernel. >> >> Hope it helps! >> >> Rick > > A bit more info, incase it helps... > > Rick > >> root@sheeva:~# cat /proc/cpuinfo >> processor : 0 >> model name : Feroceon 88FR131 rev 1 (v5l) >> BogoMIPS : 1185.79 >> Features : swp half thumb fastmult edsp >> CPU implementer : 0x56 >> CPU architecture: 5TE >> CPU variant : 0x2 >> CPU part : 0x131 >> CPU revision : 1 >> >> Hardware : Marvell Kirkwood (Flattened Device Tree) >> Revision : 0000 >> Serial : 0000000000000000 >> root@sheeva:~#