>>>>> "Terrence" == Terrence M Brannon <[EMAIL PROTECTED]> writes:
Terrence> - how do I allow DOS to be booted Terrence> from a LILO prompt? I had this same question and remember having to do more than the normal amount of manual reading to figure it out. Since the solution is extremely simple, this should not have been the case. Hopefully, this will save you from having to go through what I did. Edit /etc/lilo.conf and add the following clause to it: # DOS bootable partition config begins other = /dev/hda1 label = msdog table = /dev/hda # loader = /boot/any_d.b # DOS bootable partition config ends Change '/dev/hda1' to the right device for your system (i.e. the partition on which you have msdog installed). If it doesn't work like that, try uncommenting the load = /boot/any_d.b line. If you have any trouble, feel free to contact me directly. -- Nathan L. Cutler Linux Enthusiast http://www.cise.ufl.edu/~nlc -- TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to [EMAIL PROTECTED] . Trouble? e-mail to [EMAIL PROTECTED]