I've got a banshee card compiled into the kernel, a logitech mousewheel and a standard swedish keyboard. I've run xf86configure, are there any more tools to help us mortals get x running? :)
HERE IS WHERE THE PROBLEMS SHOW: (II) TDFX: Driver for 3dfx Banshee/Voodoo3 chipsets: 3dfx Banshee, 3dfx Voodoo3, 3dfx Voodoo5 (EE) No devices detected. Fatal server error: no screens found When reporting a problem related to a server crash, please send the full server output, not just the last messages. This can be found in the log file "/var/log/XFree86.0.log". Please report problems to [EMAIL PROTECTED] XIO: fatal IO error 104 (Connection reset by peer) on X server ":0.0" after 0 requests (0 known processed) with 0 events remaining. MY XF86 CONFIGURATION: (cut here and there) # ********************************************************************** # Core keyboard's InputDevice section # ********************************************************************** Section "InputDevice" Identifier "Keyboard1" Driver "Keyboard" # For most OSs the protocol can be omitted (it defaults to "Standard"). # When using XQUEUE (only for SVR3 and SVR4, but not Solaris), # uncomment the following line. # Option "Protocol" "Xqueue" Option "AutoRepeat" "500 30" # These are the default XKB settings for XFree86 # Option "XkbRules" "xfree86" # Option "XkbModel" "pc101" # Option "XkbLayout" "us" # Option "XkbVariant" "" # Option "XkbOptions" "" # Option "XkbDisable" Option "XkbRules" "xfree86" Option "XkbModel" "pc105" Option "XkbLayout" "se" Option "XkbVariant" "" EndSection# ********************************************************************** # Core Pointer's InputDevice section # ********************************************************************** Section "InputDevice" # Identifier and driver Identifier "Mouse1" Driver "mouse" Option "Protocol" "PS/2" Option "Device" "/dev/psaux" # Option "ChordMiddle" EndSection # ********************************************************************** # Monitor section # ********************************************************************** # Any number of monitor sections may be present Section "Monitor" Identifier "monitor" HorizSync 30-70 VertRefresh 50-120 EndSection #********************************************************************** # Graphics device section # ********************************************************************** # Device configured by xf86config: Section "Device" Identifier "gfxcard" Driver "tdfx" VideoRam 4096 # Insert Clocks lines here if appropriate EndSection # ********************************************************************** # Screen sections # ********************************************************************** # Any number of screen sections may be present. Each describes # the configuration of a single screen. A single specific screen section # may be specified from the X server command line with the "-screen" # option. Section "Screen" Identifier "Screen 1" Device "gfxcard" Monitor "monitor" DefaultDepth 16 Subsection "Display" Depth 8 Modes "640x480" "800x600" "1024x768" "1280x1024" ViewPort 0 0 EndSubsection Subsection "Display" Depth 16 Modes "640x480" "800x600" "1024x768" "1280x1024" ViewPort 0 0 EndSubsection Subsection "Display" Depth 24 Modes "640x480" "800x600" "1024x768" "1280x1024" ViewPort 0 0 EndSubsection EndSection # Each Screen line specifies a Screen section name, and optionally # the relative position of other screens. The four names after # primary screen name are the screens to the top, bottom, left and right # of the primary screen. In this example, screen 2 is located to the # right of screen 1. Screen "Screen 1" thanks, Alex -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]