This started happening recently. Sometimes when i boot up my screen floods with :
eth0: card reports no RX buffers. eth0: card reports no resources. eth0: card reports no RX buffers. over and over again.. at first i thought it was an IRQ conflict but nothing in the system had changed it just started out of nowhere apparently(after a reboot once) i figured a way around it, to /etc/init.d/networking stop then start it again after a few seconds(haven't tried to issue just a restart) and the errors stop. was wondering if this could be the result of the system booting too fast ? my system takes about 6 seconds from when init loads to when X launches(probably more like 4-5 seconds) the same hardware when i was running slower stuff(128MB as opposed to 512MB and 466mhz as opposed to 800mhz) this never happened. Running on an Asus CUV4X(VIA Apollo Pro133A). I did move the NIC from PCI#4 to PCI#2 with no difference. really odd. Running debian 2.2r0 linux 2.2.17pre18 eth0: Intel PCI EtherExpress Pro100 82557, 00:90:27:9B:16:D6, I/O at 0xa800, IRQ 10. Receiver lock-up bug exists -- enabling work-around. Board assembly 721383-006, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0x04f4518b). eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html eepro100.c: $Revision: 1.20.2.10 $ 2000/05/31 Modified by Andrey V. Savochkin <[EMAIL PROTECTED]> and others more info: [EMAIL PROTECTED]:~$ cat /proc/interrupts CPU0 0: 47060 XT-PIC timer 1: 2469 XT-PIC keyboard 2: 0 XT-PIC cascade 8: 1 XT-PIC rtc 10: 797 XT-PIC eth0 11: 0 XT-PIC es1370 12: 17762 XT-PIC PS/2 Mouse 13: 1 XT-PIC fpu 14: 0 XT-PIC usb-uhci, usb-uhci 15: 26279 XT-PIC aic7xxx [EMAIL PROTECTED]:~$ cat /proc/ioports 0000-001f : dma1 0020-003f : pic1 0040-005f : timer 0060-006f : keyboard 0070-007f : rtc 0080-008f : dma page reg 00a0-00bf : pic2 00c0-00df : dma2 00f0-00ff : fpu 02e8-02ef : serial(set) 02f8-02ff : serial(set) 0378-037f : parport0 03c0-03df : vga+ 03f8-03ff : serial(set) 0778-077a : parport0 a000-a03f : es1370 a400-a4fe : aic7xxx a800-a81f : Intel Speedo3 Ethernet b000-b013 : usb-uhci b400-b413 : usb-uhci e800-e807 : via2-smbus any idea ? thanks for any input! nate -- ::: ICQ: 75132336 http://www.aphroland.org/ http://www.linuxpowered.net/ [EMAIL PROTECTED]