I solved it, apparently the problem was the usbmouse module, modprobe -r usbmouse...
Mouse works. Riaan On Fri, 2002-06-14 at 13:47, Riaan Rottier wrote: > Hi > > I installed a USB optical mouse on my computer. After going through the > whole process as described in www.linux-usb.com the mouse worked but > only moving up and down when I move the mouse side to side. Neither the > buttons nor the up and down movement had any effect. lsmod gives: > > > Module Size Used by Not tainted > mousedev 3808 1 > hid 12544 0 (unused) > usbmouse 1792 0 (unused) > input 3264 0 [mousedev hid usbmouse] > usb-ohci 17696 0 (unused) > tulip_cb 31872 2 > cb_enabler 2528 2 [tulip_cb] > ds 6688 2 [cb_enabler] > i82365 22288 2 > pcmcia_core 41408 0 [cb_enabler ds i82365] > smbfs 30496 0 (unused) > sound 53260 0 (unused) > trident 26624 2 > soundcore 3492 4 [sound trident] > ac97_codec 9568 0 [trident] > vfat 9276 2 > fat 29112 0 [vfat] > > and /etc/init.d/hotplug status > > USB Status for kernel: Linux 2.4.17 i686 > > USB up; bus count is 1 > T: Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev#= 1 Spd=12 MxCh= 2 > P: Vendor=0000 ProdID=0000 Rev= 0.00 > S: Product=USB OHCI Root Hub > S: SerialNumber=d48a1000 > I: If#= 0 Alt= 0 #EPs= 1 Cls=09(hub ) Sub=00 Prot=00 Driver=hub > T: Bus=01 Lev=01 Prnt=01 Port=01 Cnt=01 Dev#= 2 Spd=1.5 MxCh= 0 > P: Vendor=0458 ProdID=001a Rev= 1.00 > S: Manufacturer=KYE > S: Product=WebScroll Eye > I: If#= 0 Alt= 0 #EPs= 1 Cls=03(HID ) Sub=01 Prot=02 Driver=usb_mouse > > USB Drivers Loaded: > usbdevfs > hub > usb_mouse > hid > > khubd/hotplug thread: > F S UID PID PPID C PRI NI ADDR SZ WCHAN TTY TIME CMD > 040 S 0 8 1 0 69 0 - 0 usb_hu ? 00:00:00khubd > > Any suggestions ??? > > > TNX > Riaan > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
